Clean Spark Plug; Transport; Storage; Disposal - Zipper Maschinen ZI-BG 100 Originalbetriebsanleitung

15.3

Clean spark plug

Clean the spark plug with a brush from
carbonic and other disposal. The space
between the contacts shall amount 0,6-
0,8mm.
15.4

Transport

Demount the throttle lever from the
steering handle.Drain motor oil and gear
oil completely. Pack the machine back into it`s packaging.
15.5

Storage

If stored longer than 30 days:
Drain petrol from fuel tank

Remove spark plug, drip some drops of motor oil into the cylinder. Mount the spark

plug back and pull the coil starter so that the combustion chamber gets oiled well by
the cocks.
Cover the machine well and store it at a dry and clean place.

15.6

Disposal

Do not dispose your ZI-BG100 in residual waste. Contact your local authorities
about the available disposal possibilities.
Drain the remaining petrol, motor oil and gear oil before disposing the machine
and dispose these separately in an environmetnally sound way.
A non proper disposal of the machine can lead to contamination of soil and
water which in turn will affect you in the long run as it gets through soil and
water into the food chain.
16

TROUBLESHOOTING

Fehler
If the engine does not want to
start:
When the engine stops:
When engine output drops:
The machine doesn`t work
porperly
ZIPPER MASCHINEN GmbH
BETONGLÄTTER / POWER TROWEL
www.Zipper-Maschinen.at
ZI-MOS145Gite 25
Mögliche Ursache / Behebung
Check the ON/OFF switch if it is „ON"

Check the fuel cock if on

Check for fuel, check the fuel pipe for leaks

Cold start / warm start difference

Spark plug

Carburator or air filter polluted.

Cehck fuel supply chain.

Check motor oil level.

Check air filter.

Check the air filter.

Check Gear oil, check lubrication of rotor blades, check if

rotor blades clean.
MAINTENANCE
Seite 25