Safety Devices - SHX SHX501HEAT2023 Bedienungsanleitung

Hint:
•
If the main switch is turned off, the power is off or the plug is unplugged, the unit must
be reset.
•
You can press "
Activation of the window opening detection (ONLY via remote control):
1. Press " " to put the appliance into working mode. Heat up for a moment until it is stable.
2. Press " " on the remote control. The "
display is set to "23" by default. Press "
opening detection mode, if the ambient temperature drops by 5-10℃ within 10 minutes, the
unit stops working within 30 minutes and goes into standby mode. Then press "" to switch
the unit on.
Press " " again to switch off the window opening detection. The "
and the unit returns to the previous working mode.
Below F is an example of setting 23℃ during window opening detection.
3.
4. If both the window opening detection and the weekly programme are on at the same time,
the unit does not operate during the OFF period of the weekly programme. During the
working status of the weekly programme, the temperature is based on the setting
temperature of the window opening detection. Below G is an example:
F
Hint:
Before the weekly programme is switched on, the day and period must be set, otherwise
the default state of the weekly settings is "00" and the programme

Safety devices

The overheating protection switches the unit off if it becomes too hot inside. This can happen if the
appliance cannot release its heat properly or if it cannot draw in enough fresh air.
Usually the cause is a (partial) cover of the unit, or blocked air inlet and/or outlet grilles.
" to check your time / day setting.
/
186
/ ℃ " indicator lights up. The temperature
" to set the target temperature. In window
G
will
" light goes out
not work.