SHX SHX501HEAT2023 Bedienungsanleitung Seite 182

Operation of the unit with and without remote control:
1. Connect the unit and switch it on by pressing the red 0/I switch. The
unit will then go into standby mode and show "
2. Press the "
return to standby mode.
3. Press the "
display.
" /-- " is displayed, as shown below: B. Press a second time to switch to high heat
mode and "
time to switch to fan mode and " -- " will be shown on the display as seen below: A.
4. Press the "
A B C
5. Press the button "
time setting is increased by one hour. After setting the time, the display shows the current
setting time for 5 seconds before returning to the previous display. In the meantime, the
display "
" button to switch to fan mode. It is displayed as follows: A. Press again to
" button once to start the product at low heating power and show the
/-- " is shown on the display, as seen below: C. Then press a third
" button to activate the panning function. Press again to stop it.
" to set the timer (00-12 hours). Each time you press the button, the
" lights up. The following photo shows an example of setting 8 hours:
" on the display.
182