Electrolux GA60GLISCN Benutzerinformation Seite 13

programme). Regeneration initiation has no
impact on the cycle duration, unless it occurs
in the middle of a programme or at the end of
a programme with a short drying phase. In
such cases, the regeneration prolongs the
total duration of a programme by additional 5
minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin in the
same cycle or at the beginning of the next
programme. This activity increases the total
water consumption of a programme by
additional 4 litres and the total energy
consumption of a programme by additional 2
Wh. The rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible more
than one in the same cycle) may prolong the
programme duration by another 5 minutes
when it occurs at any point at the beginning
or in the middle of a programme.
All the consumption values mentioned in
this section are determined in line with
the currently applicable standard in
laboratory conditions with water hardness
2.5mmol/L (water softener: level 3)
according to the regulation: 2019/2022 .
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
How to set the water softener level
Make sure the appliance is in user mode.
1. Press .
• The indicator
• The remaining indicators are off.
• The display shows the current setting:
e.g. = level 5.
2. Press repeatedly to change the
setting.
3. Press the on/off button to confirm the
setting.
still flashes.
7.3 The rinse aid level
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically
released during the hot rinse phase.
You can set the released quantity of rinse aid
between level 1 (minimum quantity) and level
6 (maximum quantity). Factory setting: 4.
When the rinse aid chamber is empty, the
rinse aid indicator is on, notifying to refill rinse
aid. If the drying results are satisfactory while
using multi-tablets only, you can deactivate
the dispenser and the indicator. However, for
best drying performance, always use rinse
aid and keep the rinse aid indicator active.
To deactivate the rinse aid dispenser and
indicator, set the level of rinse aid to 0.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press .
• The indicator
• The remaining indicators are off.
• The display shows the current setting:
e.g. = level 4.
2. Press repeatedly to change the
setting.
3. Press the on/off button to confirm the
setting.
7.4 AirDry
AirDry improves the drying results with less
energy consumption. The appliance door
opens automatically during the drying phase
and remains ajar.
still flashes.
ENGLISH 13