Electrolux GA60GLISCN Benutzerinformation Seite 12

negative effect on the washing results and on
the appliance.
The higher the content of these minerals, the
harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in your
Water hardness
German de‐ French de‐
grees (°dH) grees (°fH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1)
Factory setting.
2)
Do not use salt at this level.
Regardless of the type of detergent used,
set the proper water hardness level to
keep the salt refill indicator active.
Multi-tabs containing salt are not effective
enough to soften hard water.
Regeneration process
For the correct water softener operation, the
resin of the softener device needs to be
regenerated regularly. This process is
automatic and is the part of the normal
dishwasher operation.
When the prescribed quantity of water (see
values in the table) has been used since the
previous regeneration process, a new
regeneration process will be initiated between
the final rinse and the programme end.
12 ENGLISH
mmol/l
84 - 90 8.4 - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
<7 <0.7
area. Your local water authority can advise
you on the hardness of the water in your
area. Set the right level of the water softener
to assure good washing results.
mg/l (ppm) Clarke de‐
grees
835 - 904 58 - 63
755 - 834 53 - 57
645 - 754 46 - 52
505 - 644 36 - 45
395 - 504 28 - 35
325 - 394 23 - 27
255 - 324 18 - 22
185 - 254 13 - 17
70 - 184 5 - 12
<70 < 5
Water softener level
1
2
3
4
5
6
7
8
9
10
In case of the high water softener setting, it
may occur also in the middle of the
programme, before the rinse (twice during a
Water softener
level
10
9
8
7
6
1)
5
4
3
2
2)
1
Amount of water (l)
250
100
62
47
25
17
10
5
3
3