Kärcher 1.069 Betriebsanleitung Seite 14

Operation
Scope of delivery
The scope of delivery of your appliance is il-
lustrated on the packaging. Check the con-
tents of the appliance for completeness
when unpacking.
In the event of missing accessories or any
transport damage, please contact your
dealer.
Description of the Appliance
These operating instructions describe the
maximum equipment. Depending on the
model, there are differences in the scopes
of delivery (see packaging).
Illustrations on Page 2
1 Mains cable with mains plug
2 Carrying handle
3 Detergent suction hose (with sieve)
4 Appliance switch "0/OFF"/ „I/ON"
5 High pressure connection
6 Transport handle
7 Storage for accessories
8 Coupling element for water connection
9 Water connection with integrated sieve
10 Trigger gun with safety catch
11 Lock trigger gun
12 Key to detach the high pressure hose
from the trigger gun
13 High pressure hose
14 Spray lance with pressure regulation
(Vario Power)
15 Spray lance with Dirtblaster
16 Washing brush
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.
14
Before Startup
Illustrations on Page 2
Illustration
 Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
 Check the secure connection by pulling
on the high pressure hose.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
 Screw the coupling element to the wa-
ter connection on the appliance.
 Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
flow valve (Optional accessory, order no.
4.440-238) to draw in surface water, e.g.
- 6
EN
Water supply