Getting Started; Charging The Battery - BWT PK MAX Bedienungsanleitung

HOW THE ROBOT WORKS
The robot has a water-propelling nozzle at the bottom of the swivel head. Water is
first sucked in through the suction mouth at the bottom of the robot, which then
goes through the filter and is discharged via the propelling nozzle. Water jetting
from the nozzle propels the robot forward. Once the robot stops against an
obstacle such as the pool wall, its side flap sways and its swivel head turns 180
allowing the robot to move in the opposite direction. The robot moves in a
generally straight pattern in one direction and in an arc pattern in the other
direction. The robot vacuums the pool bottom as it moves, collecting debris in its
compartment.

GETTING STARTED

Charging The Battery

IMPORTANT NOTE: Fully charge the robot (about 6 hrs) before using it for
the first time.
WARNING!
 Use only the original external adaptor and charging plug provided.
 Make sure the robot and the charging port are clean and dry before set-up
and charging. (TIPS: Pry open the protective cover and use a cotton bud
to dry the charging port and charging pins)
 The charging pins are waterproof. However, remnants of water in the port
and around the pins could result in natural occurrence of stains (a
byproduct of chemical reaction between water and electric currents).
Otherwise, the stains can be removed by light scrubbing with a cotton bud
soaked with juice of lemon or vinegar.
 Make sure the robot is off by sliding the switch to the OFF position prior to
charging.
1. Place the unit on a flat surface. Slide the switch to the OFF position.
2. Pry open the protective cap. Align and attach the charging plug to the
charging port.
WARNING! Be sure not to invert the charging plug and ensure both the
charging plug and charging port are clean and dry before charging them.
TIPS: Use cotton bud to dry the charging port and pins. Plug the charging
cable of the external adaptor into the charging plug.
OFF
ON
o
,
4/195