Battery Disposal - BWT PK MAX Bedienungsanleitung

2. Battery discharges on its own during storage. Make sure to charge the robot to about
30% to 50% of the battery capacity before it is stored.
3. You must recharge the battery at least once every three months when it is not in use.
 Unplug the external adaptor from the socket and the charging plug from the external
adaptor and robot.
 Detach accessories from the robot. If necessary, rinse the robot and accessories
with fresh water. DO NOT use detergent.
 Be sure to drain the water from the robot before storage.
 Use a damp cloth to clean and dry the robot and its accessories.
 Store them in a well-ventilated area away from sunlight, heat, ignition sources, pool
chemicals and from children. Ambient temperature for storage should be 10˚C –
25˚C (50˚F – 77˚F). NOTE: A higher storage temperature may reduce the battery
life.
WARNING!
Under no circumstances should you disassemble the swivel head to replace
its internal components by yourself. Doing so would void the warranty,
expose yourself to potential hazards, and possibly damage the device and
other properties.
CAUTION!
 Excessive heat can damage the battery and reduce the lifespan of your robot as a
result.
 Consult your dealer regarding battery replacement if the following happens:
- Battery does not charge fully.
- Battery operation time is noticeably reduced. Observe and record the run times
of the first few operations (on a full charge). Use these run times as a reference
point for comparison with run times in the future.
 The battery must be removed from the robot before it is scrapped.
 The robot must be disconnected from the supply mains when the battery is being
removed.
 The battery is to be disposed safely in accordance with local ordinances or regulations.
NOTE: Incorrect maintenance may reduce the battery life and affect its capacity as a
result.

BATTERY DISPOSAL

Your robot is equipped with a maintenance-free rechargeable lithium-ion battery pack,
which must be disposed of properly. Recycling is required; please contact your local
authority for more information.
WARNING! Never attempt to disassemble a battery pack
 Remove all personal items such as rings, bracelets, necklaces and
watches when the battery pack is unwired from the robot.
 A battery can produce a short circuit current high enough to weld a ring (or
similar item) to metal, causing a severe burn in the process.
 Wear complete eye protection, gloves and protective clothing when the
battery pack is being removed.
 Avoid touching the wires altogether and avoid contact between them and
any metal items, which could cause sparking and/or short circuit the
battery.
 Never smoke or allow a spark or flame in the vicinity of the battery or the
(To be carried out by an authorized technician)
12/195