Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ASSEMBLY
DANGER: Always place the active monitor in a suitable location on a sufficiently stable, level
and horizontal surface. Make sure that the monitor cannot fall off the edge of a stage (e.g.
due to vibration). There is a risk that units that have not been set up and positioned correctly
will fall over or down. This can cause serious injury or death.
DEVICE COMPONENTS
RECESSED GRIP
1
One ergonomically shaped recessed grip each is located on the left and right below the front grille.
STAND FLANGE
2
A 35 mm flange is located on the left side of the housing. Only use suitable speaker stands!
RUBBER FEET
3
Four non-slip rubber feet are located on the underside of the cabinet. Three non-slip rubber feet are
located on the left-hand side of the cabinet for safe parking and for upright assembly.
CONNECTION PANEL
4
The recessed connection and operating panel with display is located on the right-hand side of the
housing.
HEAT SINK
5
A heat sink is located on the back of the housing. Do not cover the heat sink during operation and
ensure that air can circulate freely.
FRONT GRILLE
6
For a homogeneous appearance and to protect the speakers, there is a sturdy protective grille on the
front of the enclosure.
1
10
5
4
6
3
1
2
3
3
Werbung
Inhaltsverzeichnis
