LD Systems MON G3 Serie Bedienungsanleitung Seite 14

AUDIO SETTINGS (AUDIO)
Press the rotary-push encoder to enter the main menu and then select the AUDIO menu item by
turning the encoder (dark background). Press the encoder again to enter the sub-menu and select the
desired sub-menu item by turning the encoder. Confirm your entry by pressing the encoder. Change a
value or status by turning the encoder, confirm the value or status change by pressing the encoder.
The sub-menu items and the corresponding information can be found in the following table. Select
MAIN MENU in the submenu  and press the encoder to return to the main menu, select  HOME in
the main menu, confirm by pressing the encoder, then return to the main display. The main display
will automatically appear after approximately 12 seconds of inactivity.
AUDIO (change value or status = turn encoder, confirm value change or request information = press encoder)
MAIN MENU
Back to the main menu
PRESET
Selection of the loudspeaker preset
HIGH EQ
Setting the treble frequencies from -10 dB to +10 dB
MID EQ
Adjusting the centre frequencies from -10 dB to +10 dB
LOW EQ
Adjusting the bass frequencies from -10 dB to +10 dB
NOTCH GAIN
Narrow band reduction of a feedback frequency 0 to -12 dB
NOTCH FREQ
Setting the feedback frequency from 500 Hz to 10 kHz
DELAY
Time delay of the audio signal in 0.1 m steps up to 10 m (0m = OFF, display in metres and feet)
14
FULLRANGE
FLAT
MONITOR
MON HPF