Operation - LD Systems MON G3 Serie Bedienungsanleitung

VOLUME / PUSH FOR MENU
7
Starting from the main display, the overall volume can be adjusted directly by turning the rotary-push
encoder. Press the rotary-push encoder to enter the editing menu. Navigate the edit menu using the
rotary-push encoder, adjust system settings and change values in the corresponding menu items.
LOCK
8
To protect the active monitor from unauthorised or accidental operation, the operation can be locked
by encoder. Press the encoder for about two seconds to activate the lock, after which a lock symbol
and "LOCKED" will appear in the display for a short time, as will an attempt to enter the menu using
the encoder. To unlock, press the encoder again for about two seconds (UNLOCKED).
PRESET
9
Designation of the presets with graphic representation of the corresponding frequency curve.

OPERATION

NOTES
As soon as the monitor is correctly connected to the mains and switched on, the LD Systems logo
appears on the display for a short time. All settings, such as preset, EQ and delay are loaded as they
were before the monitor was switched off. After this process, which only takes about one second,
the monitor is ready for operation.
MAIN DISPLAY
In normal operation, the main display is activated and the display shows the set overall volume,
the activated speaker preset and the input levels of channels 1 and 2 (see illustration).
Total volume
PRESET
Input level with peak display Channel 1
VOLUME
Starting from the main display, the overall volume can be adjusted directly by turning the rotary-push
encoder VOLUME / PUSH FOR MENU. The indication in the display changes automatically to the corresponding
representation when the encoder is turned (see illustration below). After about 12 seconds of inactivity,
the main display is automatically shown again; pressing the encoder immediately changes the display
to the main display.
Input level with peak
display Channel 2
Level Peak
13