EINHELL EURO 2500-1 Bedienungsanleitung Seite 10

Anleitung Euro 2500-1 21.10.2004
GB
necessary, particularly the Putting the compressor
wearing of suitable clothing and
into operation
masks.
G The work room has to be
Assembling the wheels (1):
bigger than 30 m 3 and have
Fit the wheels as shown in
sufficient ventilation for
Figure 1.
spraying and drying. Never
1
spray into the wind.
It is always imperative to
observe the regulations of your
local police authorities when
spraying combustible or
hazardous substances.
G Never process media such as
white petroleum spirit, butyl
alcohol and methylene chloride
with the PVC pressure hose
(reduced life span).
Operation of pressure
Assembling the rubber buffer
Fit the supplied rubber buffer to
vessels in accordance
the support foot as shown in
with the pertinent
Figure 2.
pressure vessel
regulations
2
1. An operator of a pressure
vessel is required to keep the
pressure vessel in good
working order, to operate it
properly, to supervise its use,
to carry out essential
maintenance and repair work
immediately, and to introduce
essential safety measures
according to requirements.
Replacing the oil filter and
2. The supervisory authorities
installing the air filter (fig. 3)
may order essential safeguards
Use a screwdriver to remove the
from case to case.
oil filler plug and insert the
3. A pressure vessel may not be supplied stopper (2) in the
operated if it has any defects opening.
which constitute a danger to Important! Check the oil level.
Screw the air filter (1) into the
employees or third parties.
4. The pressure vessel must be hole in the side of the compressor
regularly inspected for damage, pump.
e.g. rust. If you discover any
damage, then please contact
the customer service
workshop.
10
11:32 Uhr Seite 10
3
Connecting to the power
supply:
The compressor is equipped with
a power cable and an earthing-pin
plug for connection to any 230 V
~ 50 Hz earthing-contact socket
outlet with a 16 A fuse. Long
supply lines, extensions, cable
reels and similar cause voltage
dips and may prevent the motor
from starting. Sluggishness
makes starting difficult at low
temperatures under freezing
point (0°C).
Explanation of the compressed
air fittings
1 Pressure switch
2 Safety valve
3 Pressure gauge (to indicate the
vessel pressure)
4 Pressure gauge (to indicate the
set pressure)
5 Pressure reducing valve
(pressure setting)
6 On/Off switch
4