Installing The Blades; Changing The Blade-Drive Belt - Toro TurfMaster 22207 Bedienungsanleitung

Installing the Blades

WARNING
Incorrectly installing the blades could damage
the machine or cause an injury to you or
bystanders.
Install the blades according to the
instructions.
1. Install the first blade so that it is horizontal, along
with all mounting hardware as shown in
37.
Note:
Tighten the bolt with your fingers.
Important:
Position the curved ends of the
blades to point toward the machine housing.
Be sure to nest the raised areas on each
blade driver with the recesses in the head of
its corresponding spindle, and the pins on
the other side of each blade driver with the
holes in its corresponding blade.
2. Steady each blade with a board and turn the
blade bolt clockwise with a torque wrench as
shown in Figure 38; torque each blade bolt to
82 N∙m (60 ft-lb).
Figure 38
3. Rotate the installed blade 1/4 turn until it is
vertical, and install the other blade in the same
manner as the first (refer to step 1).
Note:
The blades should be perpendicular,
forming an inverted "T" as shown in
All manuals and user guides at all-guides.com
Figure
Changing the Blade-Drive
Belt
Change the blade-drive belt as needed.
g232801
Figure 39.
28
Figure 39
1. Blade (2)
4. Tighten the second blade; refer to step 2.
5. Rotate the blades by hand a full 360° turn to
ensure that they do not touch.
Note:
If the blades touch each other, they are
not mounted correctly. Repeat steps
until the blades no longer touch each other.
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Remove the belt cover
the 4 bolts that hold it to the machine housing.
Note:
Save the bolts for installing the belt cover
to the machine housing.
4. Remove any debris from under the belt cover.
5. Remove the BBC belt guard and the mounting
hardware.
Note:
Save the BBC belt guard and hardware
for installation later.
g016536
1 through
(Figure 6) by removing
3