General; About This Document; Safety; Personnel Qualification - Dimplex UPH 70-25P Montage- Und Gebrauchsanweisungen

UPH 70-25P - UPH 80-25P

1 General

1.1 About this document

The installation and operating instructions are part of the product.
They must always be available close to the product. These

2 Safety

These operating instructions contain basic notes which must be
observed during installation and operation. It is therefore
essential for the technician and the operator to read these
operating instructions before the product is installed and started
up.

2.1 Personnel qualification

Any personnel involved in the installation must be qualified to
carry out this kind of work.

2.2 Danger in case of non-observance of the safety information

Persons and/or the pump/system are at risk if the safety
information is not observed.

2.3 Safety information for the operator

Observe the valid accident prevention regulations!
It must be ensured that there are no risks resulting from electrical
energy. Instructions resulting from local or general regulations

2.4 Safety information for inspection and installation work

The operator must ensure that all inspection and installation work
is carried out by authorised and qualified specialists who have
studied the operating instructions in detail.

2.5 Impermissible operating modes

The operating safety of the pump supplied can only be ensured if
the pump is properly used according to Chap. 4 on page 3 of the

3 Transport and intermediate storage

ATTENTION!
Danger of damage for the pump 
Danger of damage due to improper handling during transport and
storage. 
The pump must be protected against humidity, frost and mechanical
damage during transport and intermediate storage.
EN-2
instructions must be observed to ensure that the device is used
and operated as intended.
Not only the safety information listed here under Safety must be
observed, but also the special safety information listed under the
other sections and marked with danger symbols.
(e.g. IEC, VDE etc.) and from local utility companies must be
observed.
Work on the pump/system must only be carried out when the
pump/system is not operating.
Unauthorised alterations and the manufacture of spare parts are
not permitted.
operating instructions. The limit values stated in the catalogue/on
the data sheet must never be undershot/exceeded.
452115.66.20 FD 9304 www.dimplex.de