JAROLIFT TDEP Serie Original Montage- Und Bedienungsanleitung Seite 32

SETTINGS
10. Press the programming key on the motor head
again (AUF key on the switch is still pressed/
switched on).
The drive runs as long as you keep the pro-
gramming key on the motor head pressed.
By pressing the programming button several
times, you can move the roller shutter upwards
"step by step".
The roller shutter closing bar (end bar of the
roller shutter curtain) must still be visible
from the outside.
11. As soon as the desired end position "AUF" is
reached, release the programming key on the
motor head and set your switch to switching
position "AUS" or press the STOP key on your
control unit.
The end positions are stored.
Setting the end points (end positions) with the adjustment
cable (OPTIONAL)
With the help of the optionally available adjustment cable, it is possible to adjust the end points without
accessing the motor head.
LED 3
LED 2
LED 1
PROGRAM
PROGRAM
32
Adjustment cable
Motor head
ATTENTION!
Let the roller shutter roll up and down
completely several times as a test. If
the roller shutter stops at the set end
points, the limit switch setting is com-
plete and the roller shutter box can be
closed. and the roller shutter box can
be closed.