Before You Start Installation - JAROLIFT TDEP Serie Original Montage- Und Bedienungsanleitung

Before you start installation:

1. Please read the operating instructions carefully and completely before beginning the installation.
2. Ensure that the roller shutter is not damaged and that it can be opened and closed smoothly. If neces-
sary, replace damaged parts.
3. Lower the shutter completely and determine whether the motor should be installed on the left or
right side of the roller shutter casing. Always choose the shortest route to the nearest junction box, as
cables must not be laid in the roller shutter casing.
4. The end position is determined when the plastic ring is fully pushed on.
Always ensure that the motor can be pushed into the shaft until it stops.
ATTENTION!
Do not give the motor a "test run" outside of the shaft. The motor must be fully pushed into
the shaft for the end switch to operate (bearing ring adapter on the motor head).
Structure/components of the roller shutter:
Roller cap
Ball bearing
Casing holder
Steel shaft
Hanging
openings
INSTALLATION
Safety split pin
Roller shutter motor
Motor bracket
25