Direct Controls - urmet 1092/427 Gebrauchsanleitung

All manuals and user guides at all-guides.com
3.1

DIRECT CONTROLS

POWER CONNECTOR (DC) [14]
Plug the power wire of the adapter provided into the respective DC.
ON/OFF BUTTON [7]
This is used to switch the monitor on and off. The blue LED lights up when the monitor is on while when it is in red stands
for standby condition.
IMPORTANT NOTE

If the following message appears on the monitor after pressing the button (1):
NO SIGNAL
It means that a not connected video signal has been selected as input.
SELECTION BUTTONS [2-3]
They allow to select the menu options inside the OSD Menu.
VOLUME BUTTONS [4-5] AND CONFIRM [4]
They allow to change the volume (5 button increases the volume – 4 button decreases the volume).
4 button also allows to confirm each setting.
MENU BUTTON [6] AND CONFIRM
This is used to access and quit the OSD (On-Screen Display) Menu and to confirm the selected settings
VIDEO INPUT SELECTION BUTTON [7]
To select the desired signal (""PC", "HDMI", "AV1" or "AV2") press the button (7) and select the desired item with the
buttons (2-3) "DOWN" and "UP". Press the button "4" to confirm.
HDMI INPUT [13]
It allows the connection of an HDMI signal and an audio signal, coming from an external source provided with an HDMI
output
PC SIGNAL INPUT (VGA) [12]
PC input.
AUDIO INPUT/OUTPUT(VGA) [8]
Jack plugs audio input/output.
AV1 - AV2 VIDEO INPUTS [10] [11]
They allow the connection of video signals coming from external sources
AV1 - AV2 VIDEO OUTPUT [9]
This BNC output allows to repeat the AV1-AV2 video signals to another video input (another monitor or DVR).
DS1092-151 18