Operation; Service; Accessories; Description - Dustcontrol Dc 5800A Originalbetriebsanleitung

Operation

Connect the machine to a suitable power source by fol-
lowing the specifi cations found on the serial number plate
on the machine. If an extension cord is to be used with the
unit, it should be suitably rated according to the prevailing
electrical code. Check rotation of the motor at startup. On
machines equipped with a phase reverser, incorrect rotation
can be easily changed. Machines not equipped with a phase
reverser will require the service of a qualifi ed electrician to
interchange two phases in the power supply.
Th e fi lter should be cleaned 1-2 times per day with conti-
nuous running, or if the machine is equipped with a fi lter
monitor, when this is in the red area.

Service

With cleaning and maintenance on the machine, the power
cable should be disconnected from the supply. Check regu-
larly that the electrical cable is not damaged.
Th e fi ne fi lter should be changed at least once per year. Use
only original spare parts. If the machine is used with a micro-
fi lter/HEPA fi lter, this should be changed every 300 running
hours.Use breathing protection when changing the fi lter.
Care must be taken during the fi lter change not to expose
unprotected persons to harmful dust. Used fi lters should be
sealed in a plastic sack and disposed of properly.
Th e DC 5800a/c should be performance tested at least once
per year because it may be used with hazardous materials.
Worn parts must be replaced.

Accessories

Description

Plastic sacks, standard
Fine fi lter polyester
Fine fi lter
Microfi lter

Warranty

Th e warranty period for this machine is two years and co-
vers manufacturers faults. Th e warranty is valid under the
condition that the machine is used under normal conditions
on the task for which it was designed and is maintained
properly. Normal wear is not covered by this warranty.
Part No
4614
429204
4292
4422
DC 5800a 5.5 kW - 10
For fi lter cleaning:
1. Start the machine.
2. Close the shutter valve on the machines inlet.
3. With slow, even motion open the pulse top by lifting
the handle. Repeat three to six times.
4. Open the shutter valve.
5. If the fi lter condition meter reads green work can con-
tinue, if in the red, pulse clean again. If after several
repetitions, the fi lter condition still shows red the main
fi lter must be changed.
Th e container under the cyclone should be emptied when
it is fi lled to ca 2/3.
Never compromise the function of the DC 5800a/c, use
only original spare parts.
Th e turbopump has a very long maintenance free ser-
vice life. After approximately 10 000 running hours,
the radial seal between the motor and pump housing
should be greased. Bearings and seals in the motor and
turbopump should be checked and lubricated. Parts
worn beyond serviceable tolerances should be replaced
with genuine spare parts.
Other accessories — see Dustcontrol catalo-
gue.
Service performed by other than Dustcontrol or its aut-
horized agent voids automatically the warranty. No other
warranty express or implied is applicable.
Part No 9481-B