Clearaudio Emotion SE Bedienungsanleitung Seite 12

Pic. 11: Top view: cartride body aligned to the
pringted lines
If you have to change the position of the diamond tip you can unscrew the allen screw on the top of the
tonearm`s headshell and move the cartridge into the corresponding position.
Please make also sure that the leading edge of the cartridge is parallel to the marker lines of the cartridge
alignment gauge. Fix the right position through looking the headshell screw on the top.
During final tonearm and cartridge installation, always take a look from the top onto the
alignment gauge, to avoid any parallax errors.
Pic. 12: Correct installation
After setting up the cartridge, please tighten the tonearm in its base to fix it in this position.
Page / Seite 12
Lift down the cartridge and place the diamond tip of the
cartridge on the reference point on the
and make sure that the edges of the tonearm tube and
the cartridge are absolutely parallel to the marking lines
printed on the cartridge alignment gauge.
For that adjustment it is necessary to take a look directly
from the top on the tonearm and the alignment gauge.
The installation is done correctly, when at the same time
the armtube is parallel to the marking lines on the gauge,
the diamond tip is on the reference point and the leading
edge of the cartridge is parallel to the lines on the gauge.
Finally lock all screws that had been involved during the
adjustments.
Now you are ready for the anti-skating adjustment.
This also depends on the tracking force of the cartridge
and the diamond shape.
Emotion SE
Bedienungsanleitung
alignment gauge
© clearaudio electronic GmbH 2016
User manual