Clearaudio Emotion SE Bedienungsanleitung Seite 11

4.)
For the next settings, place any LP on the platter and remove the stylus protector.
If you now lift down the cartridge to the middle of the turntable platter, you must see (from the side) that
the lower edge of the tonearm tube is parallel to the surface of the record. You can use the tonearm tube
as orientation.
Pic. 9: Setting the VTA
If it is necessary you can adjust the height of the tonearm (VTA).
For that you have to move the tonearm in the chassis's hole in the right direction (up an down).
Fix the tonearm in its correct position by locking the allen screw in the tonearm base.
5.) Azimuth adjustment
If you now lift down the cartridge again and take a look at the front side of the cartridge.
You have to make sure that the upper edge of the cartridge is parallel to the record surface.
This adjustment had been set up perfectly by Clearaudio. Only if it is necessary, you can adjust the
cartridge position, while carefully screw the small allen screw on the bottom side of the tonearm tube near
the headshell (Caution: please don't unscrew the allen screw
headshell with the mounted cartridge around his roll-axis. To achieve the most precise adjustment you can
use a set square.
If you have found the right position you can carefully lock the small allen screw without changing the
position defined before.
!
Don't twist the headshell when the cartridge is lifted down and the diamond tip is on
the record. It is necessary to lift the tip from the record, before you can check the
position again.
6.)
For the final setup of the tonearm, you need the cartridge alignment gauge which is included as well.
Slide the gauge over the spindle of the turntable platter and turn the platter into the position as shown in
the picture 9.
Pic. 10: Alignment of the cartridge
Page / Seite 11
Emotion SE
Tonearm parallel
to platter
completely). Now you can twist the
© clearaudio electronic GmbH 2016
User manual
Bedienungsanleitung