Replacing Carbon Brushes; Optional Accessories - Makita DJS130Z Bedienungsanleitung

Replacing carbon brushes

Fig.14
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
First remove the holder by unscrewing the hex socket
head bolt.
Fig.15
Then loosen the hex socket head bolt that fastens the
barrel and turn the barrel counterclockwise.
Fig.16
Use a screwdriver to remove two screws then remove
the front cover.
Fig.17
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
Fig.18
Use pliers to remove the carbon brush caps of the carbon
brushes. Take out the worn carbon brushes, insert the
new ones and replace the carbon brush caps in reverse.
Fig.19
Make sure that the carbon brush caps have fit into the
holes in brush holders securely.
Fig.20
Reinstall the front cover and tighten two screws securely.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Center blade
•
Side blade R
•
Side blade L
•
Hex wrench
•
Various type of Makita genuine batteries and
•
chargers
Shear head 16 set
•
or attachments
Only use accessory or
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
are
8