English; Connecting To The Mains - Bosch GHP 5-65X Originalbetriebsanleitung

OBJ_BUCH-2319-003.book Page 23 Wednesday, May 13, 2015 10:35 AM

English

Safety Notes
Symbols on the machine
Read all safety warnings and
all instructions. Failure to fol-
low the warningsnd instruc-
tions may result in electric shock, fire
and/or serious injury.
General hazard safety alert.
Warning: High pressure jets can be dan-
gerous if subject to misuse.
According to the applicable
regulations, the appliance
must never be used on the
drinking water network with-
out a system separator. Use a separa-
tor as per IEC 61770 Type BA.
Water flowing though a system sepa-
rator is considered not drinkable.
For self priming use special suction
kit 3 m long (F 016 800 335).
User qualification and personal pro-
tection
 This machine can be used by people
with reduced physical, sensory or
mental capabilities or lack of experi-
ence and knowledge if they have
been given supervision or instruction
concerning use of the machine in a
safe way and understand the hazards
involved.
Bosch Power Tools


tect against water, particles and/or aer-
osols sprayed back from parts. Do not
Never direct the
inhale aerosols if self-priming from ex-
water jet at peo-
ternal sources. Such water can contain
ple, animals, the
disease-causing agents.
unit or electric

components.

Connecting to the mains






The unit must not be operated by chil-
dren or juveniles. Children should be
supervised to ensure that they do not
play with the unit.
The unit may only be used by author-
ised persons who have received
training or have demonstrated their
ability to operate the unit.
Wear personal protective
equipment (PPE) e. g. safety
goggles, dust mask etc. to pro-
Do not use the appliance within the
range of persons unless they also
wear protective clothing.
The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
The operating voltage is 230 V AC,
(for non-European countries 220 V or
240 V, as applicable).
This is a class I unit and may only be
connected to properly earthed power
sources.
The electric supply installation shall
be made by a qualified electrician and
comply with IEC 60364-1.
We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
English | 23
F 016 L81 097 | (13.5.15)