Meec tools 016364 Bedienungsanleitung Seite 33

TROUBLESHOOTING
Relieve the pressure, switch off the high-pressure washer and remove the battery before cleaning
and/or maintenance. See the troubleshooting schedule below in the event of any problems.
The inspection and repair of electrical components must only be carried out by qualified personnel.
Contact your dealer if you have any problems or questions.
Problem
Substantial fluctuations in
pressure.
The product will not start.
Leakage in the water
system.
Cause
The nozzle (8) is blocked.
The battery is discharged.
The connections are not correctly
connected.
Supply pressure is too high.
Action
Rinse the nozzle (8) with fresh water.
If necessary, clean the nozzle according
to the cleaning instructions.
Charge the rechargeable battery.
Switch off the product and remove the
battery. Reconnect the connections
according to the instructions.
Connect the product to a water pipe
with a maximum pressure of 5 bar.
EN
33