Cabled Master/Slave Operation - EuroLite AKKU IP Tourlight 200 Bedienungsanleitung

Cabled master/slave operation

Several devices may be interconnected (max. 32) via DMX cables. Then all slave units can be synchronized
and controlled with the master unit without the need for a DMX controller. The devices must be set to the
corresponding operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAVE is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to a stand-alone mode. The interconnected devices will now operate in sync.
Master/slave operation via QuickDMX
1 Set the master device and each slave device to the same transmission channel using the function SET
2.4G. Thus, the spotlights are paired.
2 Set the master unit to the desired operating mode and all slave units to SLAVE mode. The devices will
now operate in sync.
Battery mode
In Battery mode the program offers different options.
Press the MENU button repeatedly until the display shows the Battery mode menu. Press ENTER to
1
confirm.
2 Use the buttons UP and DOWN to choose Super for super bright mode, or select Normal for normal
mode and Economy for energy save mode. Confirm with the ENTER button. In Economy mode the
battery life is 20 hours and 4 hours with super bright mode. Confirm with ENTER.
Key lock
You can lock the operating buttons to e.g. prevent menu tampering. If the menu option PASSCODE is
enabled, the buttons will be automatically locked from the last command. In order to disable the key lock
function, press these buttons in the following order: UP, DOWN, UP, DOWN, ENTER.
QuickDMX transmission channel/Wireless 2.4G
You can use the SET 2.4G menu to set the wireless transmission channel for QuickDMX operation. Use the
buttons UP and DOWN to choose wireless transmission channel with ON (QuickDMX enabled) or OFF
(QuickDMX disabled). Confirm with the ENTER button. Please refer to the corresponding chapter for further
explanation.
30/36
00139418, Version 1.0