Technical Data; Product Properties - Hilti DX 351 M&E Bedienungsanleitung

• It is a requirement for EFTA countries that the cartridges must be CE-compliant and must bear the CE
mark of compliance.
• It is a requirement for the United Kingdom that the cartridges must be UKCA-compliant and must bear
the UKCA mark of compliance.
• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridges must have C.I.P.
approval for the DX fastening tool used.
• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.
Compatible cartridges
Ordering designation
6.8/11 M white
6.8/11 M green
6.8/11 M yellow
6.8/11 M red
3.5 Information about the field of applications
See the Hilti product page for more information about the areas of application.
4

Technical data

4.1

Product properties

Weight (basic tool)
Length (fastening tool)
Recommended maximum fastening
rate
Required contact pressure
Compression stroke
Ambient temperature (storage and
use)
4.2 Minimum distances and edge distances
You must always observe certain minimum distances and spacing when driving fasteners. They can differ,
depending on the product.
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
Min. distance to edge
(base-material edge to fastener)
Min. center-to-center distance
(between fasteners)
Min. base material thickness
*332581*
DX 351 M&E
2.7 kg
545 mm
700 fastener driving opera-
tions/h
100 N
59 mm
−15 ℃ ... 45 ℃
Concrete
≥ 70 mm
≥ 80 mm
≥ 100 mm
332581
Color Power level
white Extra-weak
green Weak
yellow Medium
red Strong
DX 351 MX
2.7 kg
545 mm
700 fastener driving opera-
tions/h
130 N
59 mm
−15 ℃ ... 45 ℃
Steel supporting structures
≥ 15 mm
≥ 20 mm
Follow the instructions in the
operating instructions of the
fastener!
English 21