Agilent Technologies TwisTorr 84 FS PCB 24 Bedienungshandbuch Seite 188

17 Technical Information
Data Exchange Protocols

control.
address

Controller address
Information available on the serial interface are listed in the
following table where the column "TYPE" points out a logic variable
with "D" (allowed values "000000" or "111111") and a numeric
variable with "N".
Variables with the first character of "Parameter Number" equal to X
can be either written or read. Variables with that character equal to
"0" can be only read, equal to "1" can be only written.
Tab. 3
PARAMETER
NUMBER
X0002
X0003
X0008
10009
00302
00303
188/210
in the case of an attempt of writing a logic parameter with a value
not equal to " 000000" or " 111111", or when the parameter is a
read only one:
1 0
param.
address
in case of an excessive time between two characters (greater than
1 second):
TYPE
D
D
D
D
D
N
TwisTorr 84 FS PCB 24 Vdc Controller User Manual / 87-901-039-01 (B)
0 6 - L O G
N A
DESCRIPTION
Low speed ON/OFF
Pump ON/OFF
Remote ON/OFF
Error acknowledgment: error
status clearing
K1 status
Error code: error code
displaying (see the following
table)
I C
check- CR
sum
K CR