Miele COMPLETE C3 SGJP3 Gebrauchsanweisung Seite 51

 Press the - foot control to select a
lower setting.
Footswitches with the option of se-
lecting interim suction power levels
Some models also offer the option of
selecting power levels in between the
standard 6 settings.
To activate this function
 Press the + footswitch until the max-
imum power level has been reached.
 Keep the – footswitch pressed until
the symbol for the lower power level
starts to flash.
 Then release the footswitch.
You can also activate this function
from the lowest power level. To do so
press and hold the + footswitch, until
the symbol for the higher power level
starts to flash.
To select an interim power setting
 Press the – or + footswitch until the
required power level has been
reached.
After a minute without touching a con-
trol, the suction power interim setting
will be saved to the next highest or low-
est setting. The flashing will stop.
The next time the vacuum cleaner is
used it will switch on with the saved in-
terim suction power level.
This setting will be deleted if you then
select one of the standard 6 power
levels.
Footswitch with Boost function
(dia. 26 + 27)
Some models also feature a Boost
power function. This function uses in-
creased power for a short period for va-
cuuming both fine and coarse stubborn
soiling.
 Press the + footswitch until the max-
imum power level has been reached.
 Then press the + footswitch again.
This activates the Boost function for 20
seconds. The Boost indicator will light
up yellow.
You now have the following options:
 Press the - footswitch before the 20
seconds have elapsed.
This switches the Boost function off
and activates maximum power.
 Press the + footswitch again once the
20 seconds have elapsed.
This activates the Boost function a
second time for 20 seconds. It can be
activated three times in a row. After
that, a pause of one minute is required
before reactivating it.
Using the Boost power level changes
the actual power consumption (see
section on EU Delegated Regula-
tions).
Radio-control handle (dia. 28)
When the vacuum cleaner is switched
on with the On/Off foot control , the
Standby indicator  on the vacuum
cleaner will light up yellow.
 Press the Standby button  on the
handle.
en
51