Replacing The Power Cable; Typical Wear Parts - HBM Machines 10577 Bedienungsanleitung

REPAIRS AT THE UNIT
10.4

REPLACING THE POWER CABLE

This may only be carried out by a skilled elec-
trician. No liability is assumed for incorrect
installation.
Switch the unit off.
Before all repair work: Unplug the power
plug from the outlet.
1. Remove the cover (1) by loosening the screws.
2. Remove the Circuit board (2) by loosening the screws.
3. Remove the Crimping plate (3) by loosening the screws.
4. Replace the unit connecting line.
5. Remount the covers carefully (do not squeeze any cables!)
10.5

TYPICAL WEAR PARTS

Despite the use of high-quality materials the highly abrasive
effect of the paints means that wear can occur at the follow-
ing parts:
Feed valve gasket
For replacing refer to Section 10.1
Outlet valve
For replacing refer to Section 10.2
(failure becomes noticeable through performance loss and/
or poor suction) The outlet valve is usually considerably more
durable than the inlet valve. Thorough cleaning may already
help here.
16