Spraying Technology; Interruption Of Work; Handling The High-Pressure Hose - HBM Machines 10577 Bedienungsanleitung

SPRAYING TECHNIQUE / HANDLING THE HIGH-PRESSURE HOSE / INTERRUPTION OF WORK
5

SPRAYING TECHNOLOGY

Move the spray gun evenly during spraying process. If this
Is not observed,and irrdgular spraing appearance will be the
result. Carry out the movement with the arm, not with the
Wrist. A parallel distance of approx 30cm between the tip and
The surface to be coated should always be observed. The lat-
Eral limitation of the spray fan should not to be too distinct.
The edge of spraying should be gradual to facilitate overlap-
ping of the next coat. The spray gun should always be held at
an angle of 90°to the surface to be coated. A spray fan aimed
obliquely at the surface to be coated leads to an unwanted
spray cloud.
6
HANDLING THE HIGH-PRESSURE
HOSE
The unit is equipped with a high-pressure hose specially suit- ed
for diaphragm pumps.
Never repair defective high-pressure hoses
yourself!
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 20 cm.
Do not drive over the high-pressure hose. Protect against
sharp objects and edges.
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a spray gun with a swivel joint and a
hose system.
Wagner recommends replacing high-pres-
sure hoses after 6 years.
Only use original-high-pressure
hoses with internal heating in order to ensure
functionality, safety and durability.
.
7

INTERRUPTION OF WORK

1. Set pressure relief valve to
2. Set ON/OFF Switch to ON/OFF.
3. Pull trigger of the spray gun to decrease the pressure of
the high pressure hose and the spray gun.
3. Secure the spray gun, refer to the operating manual of the
spray gun.
4. Remove tip from tip holder and store the tip in a small
ves- sel with suitable cleaning agent.
5. Leave the suction system immersed in the coating mate-
rial or immerse it in the corresponding cleaning agent.
The suction filter and unit should not dry out.
6. Cover the material container in order to prevent the paint
from drying.
In using quick-drying or two-component
Coating materials, do not fail to rinse unit
Through with a suitable cleaning agent dur-
ing the processing period.
11
(pressure relief, circulation).