Cleaning Preserving Agent When Starting-Up Of Operation Initially; Ventilate Unit (Hydraulic System) If The Sound Of Inlet Valve Is Not Audible; Taking The Unit Into Operation With Coating Material - HBM Machines 10577 Bedienungsanleitung

STARTUP
4.4
CLEANING PRESERVING AGENT WHEN
STARTING-UP OF OPERATION INITIALLY
Unit with suction tube
1. Immerse the suction system into a container filled with a
suitable cleaning agent (recommendation: water).
2. Set pressure relief valve (1) to
3. Switch the device on (Pos. I) using the ON/OFF switch (2).
4. Slowly turn the pressure regulating knob (3) to the right.
5. Wait until you can hear the sound of the inlet valve and
cleaning agent flows from the return hose.
6. Turn the pressure regulating knob (3) back approx. one
rotation.
7. Set pressure relief valve (1) to
Pressure is rising up inside the high pressure hose (visible
at pressure gauge (3)).
8. Point the tip of the spray gun to inner wall of an open and
empty metal container and pull the trigger at the spray
gun.
9. The pressure is increased by turning the pressure regulat-
ing knob (2) to the right. Set approx. 10 MPa (1500 psi) at
the pressure gauge.
10. Spray the cleaning agent out of the unit for approx.
1 - 2 min. (~5 litres) into the open collecting container.
4.5
VENTILATE UNIT (HYDRAULIC SYSTEM) IF THE
SOUND OF INLET VALVE IS NOT AUDIBLE
1. Switch the device on (Pos. I) using the ON/OFF switch (4).
2. Turn pressure regulating knob (2) approx. three revolu-
tions to the left.
3. Set pressure relief valve (1) to
draulic system is ventilated. Leave the unit on for two to
three minutes.
4. Then slowly turn pressure regulating knob (2) to the right
until you can hear the sound of the inlet valve.
5. If not, repeat points 2 and 4
( circulation).
(spray).
(circulation). The hy-
10
4.6
TAKING THE UNIT INTO OPERATION WITH
COATING MATERIAL
Unit with suction tube
1. Immerse the suction system into a container filled with
coating material.
2. Set pressure relief valve (1) to
3. Switch the device on (Pos. I) using the ON/OFF switch (4).
4. Slowly turn the pressure regulating knob (2) to the right.
When the noise of the valves changes, the unit is bled and
takes in coating material.
5. If coating material exits from the return hose, turn the
pressure regulating knob (2) back approx. 1 rotation.
6. Set pressure relief valve (1) to
Pressure is rising up inside the high pressure hose (visible
at pressure gauge (3)).
7. Pull the trigger of the spray gun and spray into an open
and empty container in order to remove the remaining
cleaning agent from the unit. When coating materials ex-
its from the tip, close the spray gun.
8. Adjust the spraying pressure by turning the pressure reg-
ulating knob (2).
9. The unit is ready to spray.
( circulation).
(spray).