Troubleshooting; Disposal - Stauff Sltsd Bedienungsanleitung

Bedienungs- und Installationsanleitung
Installation- and Operation Instruction
Niveau-Temperaturschalter mit Display /
Level-Temperatur Switch with Display

5.3 Troubleshooting

If an error occurs, all outputs are set idle. All four LEDs flash. Errors are stored until the device is shut off.
Problem / Failure
No display
Error messages on the display: toggles between
Error 01
Error 02
Error 04
Error 08

6 Disposal

Regard the local regulations for disposal of electric and electronic equipment.
Possible cause
Mains disconnected
Ambient temperature too low
Ambient temperature too high
Pt 100 (RTD) defective (short cut)
Pt 100 (RTD) defective (broken
wire)
07/2013
Check cables and replace them if
necessary
and Exxx: e.g.
Keep limits according to technical
data
Keep limits according to technical
data
Replace measurement cable
Pt 100 (RTD)
Send the device for repair
Replace measurement cable
Pt 100 (RTD)
Send the device for repair
Solution
43