Switching Output X: Delay For Reset Point; Switching Output X: Testing The Switching Output - Stauff Sltsd Bedienungsanleitung

Bedienungs- und Installationsanleitung
Installation- and Operation Instruction
Niveau-Temperaturschalter mit Display /
Level-Temperatur Switch with Display

4.7.5 Switching Output x: Delay for Reset Point

The delay for the set point is set in the following menu:
Meas. value
Main menu meas. value
Range:
0...100 seconds

4.7.6 Switching Output x: Testing the switching output

The switching output can be tested in the following menu:
Meas. value
Main menu meas. value
Out X EF X
Settings OUTX
Delay for reset point OUT x
Time in seconds which the signal must at least remain to enable the switch to
operate.
Note:
- If the output characteristic is set to Window the value represents the time
delay for the signal leaving the measurement window.
- If the output characteristic is set to Frequency Output, this value has no
effect.
Out X EF X
Settings OUTX
Testing the switching output
The following options are available if
normal operation
The following options are available if
normal operation as
frequency output
Note:
- After finishing the tests, make sure to reset the function to "normal
operation" .
Delay RP X
Extenden functions Delay for OUTX off
Check Out X
Extenden functions
is set to
turns the switching
output off
is set to
output
frequency 1 Hz
07/2013
Parameter
Parameter
Test for OUTX
/ / /
turns the switching
output on
output
frequency 100 Hz
:
37