Switching Output X: Upper Limit (Set Point); Switching Output X: Lower Limit (Reset Point); Switching Output X: Delay For Set Point - Stauff Sltsd Bedienungsanleitung

Bedienungs- und Installationsanleitung
Installation- and Operation Instruction
Niveau-Temperaturschalter mit Display /
Level-Temperatur Switch with Display

4.7.2 Switching Output x: Upper Limit (Set Point)

The upper limit for switching output x (set point) is set in sub-menu:
Out X
Meas.value
Settings OUTX
Main menu meas. value
Range
0 °C to 100 °C
(32 °F to 212 °F)

4.7.3 Switching output x: Lower Limit (Reset Point)

The lower limit for switching output x (set point) is set in sub-menu:
Meas.value Out X
Main menu meas. value Settings OUTX
Range
0 °C to 100 °C
(32 °F to 212 °F)

4.7.4 Switching Output x: Delay for Set Point

Menu Extended Functions EF1 provides further settings for switching output x. The menu is located on
the second sub-menu level.
The delay time for set point and reset point avoids too many false alarms in case of fluctuating conditions.
The delay for the set point is set in the following menu:
Meas. value
Main menu meas. value
Range:
0...100 seconds
Upper limit 1
Set point for OUT x
Note:
- The set point must be set within the measuring range (see menu Basic
extended functions
- If the switching characteristic is set to window,
The set value represents the upper window limit.
- If the switching characteristic is set as frequency output,
displayed. The set value represents a frequency of 100 Hz.
Reset point X
Reset point for OUT x
Note:
- The reset point
- If the switching characteristic is set to window,
The set value represents the lower window limit.
- If the switching characteristic is set as frequency output,
displayed. The set value represents a frequency of 1 Hz.
Out X EF X
Settings OUTX
Time in seconds which the signal must at least remain to enable the switch to
operate.
Note:
- If the output characteristic is set to Window the value represents the time
delay for the signal remaining within the measurement window.
- If the output characteristic is set to Frequency Output, this value has no
effect.
).
must be set within the measuring range.
Delay SP X
Extenden functions Delay for OUTX on
07/2013
Parameter
is displayed.
Parameter
is displayed.
Parameter
is
is
36