Using For The First Time - Swim & Fun Santorini XL Pool Bedienungsanleitung

UK
5.2 Connection to the pool (figure 10)
1. Skimmer: Connection from the skimmer to
the pump. The suction hose that takes the
uncleaned water from the pool (pool skimmer)
to the pump must be fitted to the pump's inlet
nozzle with hose clamps.
2. Return: The hose that takes the cleaned
water back to the pool must be fitted to the
return nozzle on the filter tank.
All hoses should be properly fixed with hose
clamps. Any leakage can be remedied by using
tape on the thread.
Fill the pool with water – ensure that the
water line reaches the middle of the pool
skimmer opening.
Now the system can be started up.
6.

Using for the first time

The filter system must not be run without water, since the water cools the system. The warranty
does not cover damage caused by the filter system being run without water.
1. Before you start the filter system, ensure that the system is located beside the pool at the same
level as the bottom of the pool and that all the connections are firmly clamped.
2. Let the water flow from the pool to the filter system. Make sure that the water is naturally flow-
ing to the pump through the suction hose from the pool. The pump is not self-priming! There-
fore, both the pool hose and the pump must be completely filled with water (primed) before first
use.
MV-1087-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
57