Drip Tray And Collecting Tray; Dispensing Unit, Beer Tap And Beer Hose; Storage; Troubleshooting - Clatronic BZ 3740 Bedienungsanleitung, Garantie

Drip Tray and Collecting Tray

1. Remove both the drip tray and the collecting tray from
the appliance.
2. Pour the accumulated beer into a sink.
3. Clean both components with hot water. If required, you
can add some manual washing-up liquid to the rinsing
bath.

Dispensing Unit, Beer Tap and Beer Hose

For this procedure you will need the cleaning balloon,
the cleaning hose, a container that holds about 2 litres of
clean, warm water and an empty container the water will be
drained into.
1. Place the empty container underneath the beer tap.
2. Fill the cleaning balloon with the warm water.
3. Connect the dispensing unit to the beer hose. The click
connection must audibly engage.
4. Plug the cleaning balloon onto the end of the keg tap.
5. Use one hand to open the tap. Use your other hand to
hold and press the cleaning balloon. Pump all the water
from the balloon through the dispensing unit and the
beer tap.
6. Repeat this procedure several times.
7. Remove the dispensing unit from the beer hose.
If a problem occurs, it is often just a small matter. Before contacting our customer service, please note the following:
Problem Possible cause
The appliance does The appliance is not connected to mains power.
not work.
The appliance is defective.
No beer is dispensed. The 5 litre party keg is empty or there is not a
5 litre party keg in the beer dispenser.
The CO
The keg tap is not fitted.
The keg is not correctly tapped.
The tap handle is not correctly installed.
BZ3740_IM_new

Troubleshooting

cartridge is empty.
2
8. Disassemble the dispensing unit into its 3 components.
To do this, turn the keg tap and remove it from the fitting.
9. Clean these components under running warm water.
Thoroughly rinse the keg tap.
In order to clean the beer tap with the beer hose but without
the dispensing unit, proceed as follows:
1. Connect the cleaning hose with the balloon. If you have
used the beer hose with Heineken kegs, you only need
the balloon.
2. Attach the cleaning hose to the tip of the beer hose. For
Heineken kegs, put the balloon on the beer hose.
3. Use one hand to open the beer tap. Use your other hand
to hold and press the cleaning balloon. Pump all the
water from the balloon through the beer hose.
4. Repeat this procedure until the beer hose is clean.

Storage

• Clean the appliance as described and let it dry com-
pletely.
• We recommend that you store the appliance in its
original packaging when it is not to be used for a longer
period.
• Always store the appliance at a well ventilated and dry
place outside the reach of children.
Solution
Check the wall outlet with a different appliance.
Insert the plug properly in the wall outlet.
Check the fuse.
Contact our service or a repair centre.
Place a new 5 litre party keg in the dispenser.
Change the CO cartridge.
2
Attach the dispensing unit to the keg by using
the keg tap. Tap the keg correctly.
Install the tap handle correctly.
49
13.09.22