Inhaltsverzeichnis
Werbung
Exercise Monitor Instruction
E04
Incline self-learning
fault
E05
Overload protection
E06
External deficiency
E07
No safety lock
signal is detected
on the computer
E09
Overload protection
in operation
recognizes of the
voltage transformers
more than 6A for
more than 3 Seconds
Er1: Faulty connection to the cockpit
Er2: Overvoltage
Er3: Overcurrent
Er4: Overweight
Er5: Motor connection
Er6: Faulty connection to the control panel
SAFE: Safety protection
1. Check the connection of the incline motor cable.
2. Check whether the AC cable of the incline motor is in the correct
position connector.
3. Check the incline motor cable for a
1. If the voltage is too high, the system protects itself. Start the device again.
2. If the voltage transformer is defective, replace it.
1. Check whether the connection of voltage transformer and motor correctly.
2. The motor is defective.
1. The safety key is not appropriate. Put it in the console.
2. The safety key is not correct. Correct the seat.
1. Check that the unit is sufficiently lubricated. Unless, Lubricate it (see
page 16).
2. The user exceeds the maximum weight. This user do not allowed use
the appliance.
3. If the voltage transformer is defective, replace it.
34
Werbung
Inhaltsverzeichnis
