Cameo CLP56RGB10 Bedienungsanleitung Seite 14

MODE SELECTION / MODUS AUSWÄHLEN / SÉLECTION DE MODE / SELECCIÓN DEL MODO / WY-
BÓR TRYBU / SELEZIONE DELLE MODALITÀ
EN NOTE
When the projector is properly connected to the mains, the following information appears successively in the display during the startup process:
"Software Update, Please Wait..." (for service purposes only), the software version "Software V1.xx" and "WELCOME TO cameo". After this operation,
the projector is ready for use and changes back to the mode that was previously selected.
STATIC COLOUR MODE
Press the mode button and use the up and down buttons to select one of the 7 desired colours.1, Red 2, Green 3, Blue 4, Yellow 5, Cyan 6, Purple 7 White
COLOUR CHANGING MODE
Press the mode button to select the Colour Change programme. The unit will then run in Colour change mode. Press the up and down buttons to
select the colour change speed from 0-99.
COLOUR FADING MODE
Press the mode button to select Fade mode. The unit will then run in colour fade mode. Press the up and down buttons to select the fade speed from
0-99.
AUTO RUNNING MODE
Press the mode button to select Auto mode. The unit will then run automatically through all of the built-in programmes. The run speed can be pre-set
via the speed of the colour change and colour fade modes.
SOUND CONTROL MODE
Press the mode button to select sound mode. The unit will then run via the sound. Press the up and down buttons to adjust the sound sensitivity
levels.
SLAVE MODE
Press the MODE button to enter SLAVE MODE.
Link the slave unit and the master unit via DMX cable. The slave unit will follow in sequence with the master unit.
14