Programming Auto Heat Up; Stop & Go Function; Recall Function - Novy Panorama Power 1831 Bedienungsanleitung

Select the timer
‐ +
Press and on the timer at the same time
and if necessary press simultaneously again
until the hourglass of the relevant zone is
highlighted
Reduce the time
‐
press on the timer
Increase the time
+
press on the timer
After a few seconds the LED no longer flashes [ min ]. The time
has been selected and the countdown has begun.
Switch off the timer function
Select the timer
‐ +
Press on and at the same time until the
desired hourglass lights up
Stop the timer
‐
Keep pressing on the timer until the timer
displays 000 ,
or set the power of the cooking zone to
If different timers are to be activated on multiple zones, this
operation must be repeated several times. The activated timer
lights up next to the appropriate zone.
The timer can also be used as an independent cooking alarm
without selecting a cooking zone. If the hob is to be switched
off, the independent cooking timer will continue until the end of
the set time.
Using the timer without cooking
Timer without cooking
Switch on the hob. Press
Select the timer
‐ +
Press and simultaneously on the timer
Reduce the time
‐
press on the timer
Increase the time
+
press on the timer
After a few seconds the LED no longer flashes [min]. The time
has been selected and the countdown has begun.
Turn off automatically at the end of the cooking time:
As soon as the selected cooking time is up, the display will flash
000
, a beep will be heard, and the cooking zone will turn off.
To stop the audible signal and the flashing, press
timer.
060‐
059...
001‐
002...
Display
remaining
time
000
0
Display
000
060‐
059...
001‐
002...
‐ +
or on the
– 70 –

5.3.6 Programming auto heat up

All cooking zones are equipped with an auto heat up function.
The cooking zone will initially operate at full power for a certain
amount of time before automatically reducing to the selected
power level.
Programming auto heat up
Activating auto heat up
Glide your finger over the slider to (for example)
7
and hold for 3 seconds
Switching auto heat up off
Glide your finger over the slider
Auto heat up table
Set value for cooking time
1
2
3
4
5
6
7
8
9
5.3.7 Stop & Go function
This function temporarily interrupts the activity of the hob and
allows a restart with the same settings.
Turning Stop & Go on and off
Switching on
II
Press
Switching off
II
Press
Then press the animated slider

5.3.8 Recall function

After turning the hob off
to recall the last selected settings: (this up to a maximum of 10
seconds)
– State of all cooking zones (power)
– Minutes and seconds of the programmed cooking zones by
the timers
– "Automatic cooking" function
– Keep warm function
The recall procedure is as follows:
– Push the control key
II
– Push before the flashing stops.
The previous settings are now active again.
Display
7 A
Display
0 9
0‐9
to
Auto heat up function
Time (min:sec)
0:40
01:12
02:00
02:56
04:16
07:12
02:00
03:12
--:--
Display
I I
0‐9
, it is possible