Domo DO7313M Gebrauchsanleitung Seite 12

DO7313M
PARTS
1. Power on/off switch
2. Control lights power I and II
3. Temperature control indicator
4. Temperature control knob
REMOVE PACKAGING
Take out the heater from the gift box.
Open the gift box and take out 2 plastic bags.
One bag conains 2 feet with casters.
Another bag contains 2 mounting locks, 2 screws and mounting anchors.
Remove the poly-foam from both ends of the heater and remove the poly-bag.
Save the packaging to store the heater while it is not used or in summer season.
INSTALLATION
Carefully unpack the components and check that no damage was caused during
transportation. If any damage is apparent or any component is missing please contact
your dealer immediately.
The box contains :
1 heater
2 feet
2 mounting locks
2 screws
Floor standing :
Fix the feet to the bottom of the heater using the built in slots.
Wall mounting use :
Mark screw holes location on the wall. Make sure the 2 holes are at the same level.
Drill holes in the wall.
Insert screw anchor into the holes.
Mount the wall supports into the holes on the wall and tighten them.
Once the wall supports are installed, put the heater on the supports.
To prevent the heater from coming loose you can lock the wall mount.
Insert the screwdriver in the upper-hole of the mounting lock and turn 90°.
OPERATION
Ensure that the temperature control knob is at "dot" position. Also make sure the
power switch is at the "off" position.
Plug the power cord into a suitable electrical outlet, rated no less than 16 Amp.
Switch the power to I or II, the orange control light will light up.
Turn it to the "on" position, then adjust the temperature conrol knob clock-wise
12
1
2
3
4