Hendi 239421 Gebrauchsanweisung Seite 8

Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning and storage.
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the cooled exterior surface with a slightly
damp cloth or sponge with some mild soap solu-
tion.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
Troubleshooting
If the appliance does not function properly, please
check the below table for the solution. If you are
still unable to solve the problem, please contact the
supplier/service provider.
Problems
GB
The appliance does not switch ON.
Cooling fan is operating even after
the appliance is switched to Stand-
by mode.
Technical specification
Item no.
Operating voltage & frequency
Rated input power
Temperature setting
Power setting
Timer setting
Protection class
Waterproof protection class
Dimension
Net weight
Remark: Technical specification is subjected to change without prior notification
8
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Store the appliance in a cool, clean and dry place.
• Never put heavy objects on the heating surface
during storage as it may crack it.
• Error codes shown on the digital display (3). (See
--> Error codes display)
Possible cause
- Power plug is not connected properly
with the electrical outlet.
- On/Standby (1) button is not pressed.
- This is normal. The cooling fan contin-
ues running in Standby mode for some
time to cool down all internal elements.
239292
35°C ~ 240°C (with 5 °C interval)
Possible solution
- Check the power plug to make
sure it is connected properly.
- Press the On/Standby (1) button to
start operation.
- Wait until the cooling fan stops ro-
tating.
220-240V~ 50/60Hz
3500W
100W ~ 3500W
Up to 180 minutes
Class I
IPX3
337x417x(H)85 mm
6.6 kg
239421