Hendi 239421 Gebrauchsanweisung Seite 7

Setting Temperature level
• During operation, press the temperature button
(7) to activate. The indicator light (7) will light up.
• Use the increase setting (3) or decrease setting
button (5) to increase or decrease the tempera-
ture level (Range: 35°C ~ 240°C). Default setting
is 100°C. Higher temperature level is suitable for
roasting, grilling or frying.
Setting Timer
• After power or temperature setting for cooking,
you can opt for timer setting. Press the timer but-
ton (2) to activate. The indicator light (2) lights up.
• Use the increase setting (3) or decrease setting
button (5) to increase or decrease the cooking
time (Range: 0 min ~ 180 mins). Default setting
is 0 min.
• When the timer is set, it will be stored automat-
ically within 5 seconds. The appliance will then
Note:
1) Press and hold the increase setting button (3) or
decrease setting button (5) for fast adjustment.
2) After an extended period of operation, it is nor-
mal for the cooling fan inside to continue run-
ning in Standby mode for some time. Before
Error codes display
Error codes shown on the display (4)
E 1
E 2
E 3
ATTENTION! The programmed temperature is that
of the glass plate and not the temperature in the
pan!
start operation. It will display the remaining time
and the power setting / temperature setting al-
ternately on the display (4).
• The appliance will go into Standby mode when
the set time is elapsed.
• If the set time is reduced to "0 min" manually,
the appliance will go into Standby mode instantly.
unplug the appliance, wait until the cooling fan
stops running.
3) The appliance's surface is still hot after switch to
Standby mode. Wait completely cool down before
touching.
Possible cause
The temperature of the appliance is
too high
Cooling fan defective
The pan or pot is overheated.
Possibly, the pan becomes empty and
appliance will shut down for protec-
tion.
The supply voltage is abnormal. (Sup-
ply voltage is too high or too low)
Possible solution
Clear all obstacles that around the
appliance. Unplug the appliance, re-
move the pan or pot, wait until the ap-
pliance is completely cool down.
Contact the supplier.
Unplug the appliance, remove the
pan or pot, wait until the appliance is
completely cool down. And make sure
water is inside the pan.
Make sure that the appliance is con-
nected to a suitable electrical power
supply.
GB
7