Trouble Shooting; Possible Cause - Texas A/S Power Split 600 VG Bedienungsanleitung

9. Trouble shooting

Problems may arise when you use the log splitter, in case of any problems we recommend
that you read the trouble shooting part. If the process is carried out by an unauthorized
person the warranty is not valid and the manufacturer will not be responsible for any
damages on persons, animals or objects.
PROBLEM
The log will not be split
The log pusher advances
jerkily or with strong
vibrations
Oil leaks from the ram or
from other external points
PLEASE READ THE FOLLOWING CAREFULLY
ALL REPAIRS AND REPLACEMENTS MUST BE CARRIED OUT BY AN AUTHORIZED
DEALER AND NOT BY THE PURCHASER. THE PURCHASER ASSUMES ALL RISKS
AND LIABLILITIES ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT OF PARTS THERETO OR INSTALLATION OF THESE.
Due to continued product development Texas A/S preserves the right to improve the
product without improving already sold models.

POSSIBLE CAUSE

The log has been placed
incorrectly
The log exceeds the
approved dimensions or the
log is too hard for the logs
ability.
The wedge does not split
The oil leaks
The hydraulic pressure is too
low
Air in the circuit
Leakage in the tank
The oil seal is worn
www.texas.dk
TROUBLE SHOOTING
Place the log correctly
Split a smaller piece or use
other remedies to reduce the
size of the log
Sharpen the wedge and
inspect for burrs and nicks
Locate the leakage by using
a piece of paper, contact
your dealer
Contact your dealer
Inspect the oil level. Fill up if
necessary. If the problem
continues, contact your
dealer
Check that the bleed screw
has been tightened before
moving the machine (fig. 6)
Contact your dealer
27