Operation - Texas A/S Power Split 600 VG Bedienungsanleitung

6. Operation

The diameter of the log is only indicative. A small piece of wood can be difficult to split if it
has knots or if its fibres are very tough. A larger piece of wood can be split if its fibres are
smooth and loose.
Never force the log splitter to split more than 5 seconds with the cylinder under pressure in
order to split excessively hard wood. Overheated oil under pressure may damage the
machine. It is very important that if the log splitter does not split in the first attempt, please
stop the machine and rotate the log 90 degrees. If the wood still cannot be split, it means
that the hardness of the wood exceeds the capacity of the machine and it must be rejected
in order not to damage the log splitter.
When splitting both handles shall be used
as shown on picture.
Variable cutting length from 10-105 cm.
Height is adjusted by pressing down (vertical)
both handles to the requested length. Here you
let go of the handle (shown with arrow).
Loosen the knurled nut (shown) and the bar
Indicating the height is pulled up and the knurled
nut is retightened (shown).
In order not to load the splitting head more than necessary it is important that you place
the wood to be split correctly. The wood shall always be placed as close to the splitting
piston as possible. If the wood is placed so that the splitting head only hits the tip an
unnecessary load on the piston arises.
www.texas.dk
25