To Adjust The Front Wheel Toe-In And Camber - Husqvarna TC 238TX Bedienungsanweisung

• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around
the transaxle fan and cooling fins.
• Examine the cooling fan to make sure the fan
blades are clean and not damaged.
To examine the transaxle pump fluid
• Make sure that the transaxle pump fluid does not
leak.
• Speak to the nearest approved service center or
department if the transaxle pump fluid leaks.

To adjust the front wheel toe-in and camber

The front wheel toe-in and camber is correctly set at
the factory. The front wheel toe-in and camber are
not adjustable.
• Speak to an approved service center if the
factory-set front wheel toe-in or camber is
damaged.
To replace the fuse
This product has an automotive-type fuse. The fuse
holder is located behind the dashboard.
1. Hold the fuse holder and pull the blown fuse out.
2. Put a new fuse in the fuse holder.
To remove and install the engine cover and
the grill assembly
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover
on its sides. Tilt the engine cover in the direction
of the engine and lift it to remove it from the
product.
4. Install in the opposite sequence.
26
A
To replace the motion drive belt
B A
C
D
E
F
Park the product on a level surface. Engage the
parking brake. Refer to the belt installation decal on
the bottom side of the left footrest.
1. Remove the belt.
a) Remove the mower. See
install the cutting deck on page 28 .
Note:
Be careful with the motion drive
belt and the position of the belt guides and
keepers.
b) Disconnect the clutch wire harness (A).
c) Remove the anti-rotation link (B) on the right
side of the product.
d) Remove the belt from the stationary idler (C)
and clutching idler (D).
e) Remove the belt from the centerspan idler
(E).
f) Pull the belt to the rear part of the
product. Carefully remove the belt from the
transmission input pulley and above the
cooling fan blades (F).
g) Remove the belt from the engine pulley and
around the electrical clutch (G).
h) Move the belt to the rear part of the product
and off the steering plate (H). Remove from
the product.
2. Install the new belt from the rear part of the
product to the front, and above the steering plate
(H) and clutch brake pedal shaft (I).
a) Pull the belt to the front of the product and
install the belt around the electrical clutch and
onto engine pulley (G).
b) Pull the belt to the rear part of the product.
G
H
I
To remove and
1962 - 001 - 23.09.2022