Husqvarna TC 238TX Bedienungsanweisung Seite 12

4. Push the ends (B) of the front frame (C) through
the loops in the fabric.
A
D
5. Push the 2 screws (A) through the fabric (D) and
the frames.
6. Install the 2 nuts.
CAUTION:
torqe of 11 Nm.
7. Push the front frame into the clips (E) in the front
of the floor of the grass catcher.
8. Push the 4 clevis pins (F) through the frames and
the 2 cross braces (G).
F
H
F
H
G
9. Install the 2 retainer springs (H).
10. Push the grass catcher handle (I) through the
hole in the top of the grass catcher.
K
J
11. Install the clevis pin (J) and the clip (K).
12
C
B
C
E
Use a maximum
I
To install the grass catcher brackets
1. Install the grass catcher bracket (A) and tighten
the 2 screws and the 2 nuts (B). Make sure that
the top edges of the brackets (C) align.
A
2. Install the offset strut (D) and the 4 carrage bolts
(E).
E
3. Install the 2 pivots (F).
F
H
4. Install the 2 washer head bolts (G).
5. Install the 4 nuts (H).
To install the spring latches for the
grass catcher
The spring latches for the grass catcher are on the
rear plate, 1 at each of the bottom corners.
Note:
If you adjust the vertical position of the
grass catcher, it can be necessary to adjust the
spring latches for the grass catcher.
1. Stop the engine and engage the parking brake.
C
B
E
D
G
1962 - 001 - 23.09.2022