Operation; To Set The Product In Operation Position - Husqvarna LC 141iV Bedienungsanweisung

2. Put the mulch plug into the grass discharge channel.
The mulch plug of type A is for LC 141i and
LC 141C. Type B is for LC 141iV.
A
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.

To set the product in operation position

If the handle is put in transport and storage position (see
To set the product in transport position on page 23 ), do
the procedure that follows to put the handle in operation
position.
919 - 010 -
B
Before you operate the
3. Close the rear cover.
4. Replace the blade with the Combi blade, see
remove and replace the blade on page 21 .

Operation

1. Lift the handle until the lower handle locks into
operation position.
2. Move the lower knobs up in the direction of the
handle until they stop and you hear a click.
3. Tighten the knobs.
To
15