Husqvarna TC 238TX Bedienungsanweisung Seite 13

2. Remove the 4 screws from the spring latches.
3. Install the spring latches (A) in the holes in the
backplate (B).
D
A
4. Make sure that the spring latches connect to the
slots (C) in the backplate.
5. Attach the 4 screws (D).
6. Attach the 2 springs (E).
To adjust the bagger
The bagger is factory installed on the product.
2
1. Loosen the adjustment bolt (2) with a 1/2"
(13mm) wrench. Do not remove the bolt.
1962 - 001 - 23.09.2022
C
B
E
1
1
2. Do step 1 on the opposite side.
3. Make sure that the clearance between the fender
and the bagger assembly top is approximately
0.25" (6mm).
4. Tighten the 2 adjustment bolts to 100 In-Lbs/11,2
Nm.
5. To align the fender and the bagger assembly top
correctly (B), adjust the vertical position of the
bagger assembly.
6. Lift or lower the bagger support brackets (4) to
correct position and tighten the nuts (3).
4
7. Replace the bagger assembly on the bagger
supports (4).
8. Do the necessary adjustments.
To install and adjust the full lever/
extension for the grass catcher
1. Stop the engine and engage the parking brake.
2. Remove the center discharge chute. Refer to
remove and install the center chute on page 29 .
3. Remove the bolt (A).
B
C
4. Put the full lever shroud (B) in the slots (C).
3 3
3
To
A
13