Husqvarna TC 238TX Bedienungsanweisung Seite 29

10. Remove the clips (H) and disconnect the
suspension arms (I) from the chassis pins.
11. Disconnect the rear lift links (J) from the rear
cutting deck brackets (K) on each side of the
cutting deck.
12. Remove the cutting deck from the product.
13. Install the cutting deck in the opposite sequence.
Make sure that the grass discharge is on the
right side of the product.
Note:
The suspension arms must be in
forward position before you move the cutting
deck below the product.
To remove and install the center chute
1. Remove the grass catcher.
2. Remove the clips (A).
A
3. Move the center chute (B) out from behind the
product.
4. Install in the opposite sequence.
To adjust the parallelism of the cutting deck
To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right
and left side of the product, the cutting height can
1962 - 001 - 23.09.2022
be adjusted. Adjust the cutting height on the side of
cutting deck that has the lower cutting height.
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
adjustment.
4. Adjust the cutting height with a 3/4" wrench.
B
Note:
changes the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to
A
lower the cutting deck.
b) Turn the lift adjustment nut (A) to the right to
lift the cutting deck.
5. Cut some grass and examine the results. Adjust
if it is necessary.
To do a precision side to side adjustment of the
cutting deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position.
Refer to
position or mow position on page 17 .
4. Turn the outer blade tips to align with the cutting
B
deck side to side.
5. Measure the distance (B) from the bottom edge
of the blade to the ground on the left and right
side.
B
Note:
sides.
6. Adjust the cutting height with a 3/4 in wrench.
Some models only have left side
A
Each full turn of lift adjustment nut
To set the cutting deck in transport
WARNING:
The blades on the
cutting deck are sharp and can
cause injury. Use protective gloves.
The distance must be the same on the 2
B
29