Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9
The REMOTE port is for connecting the cable of the included bass level remote controller. With this, the bass level can be e.g.
be adjusted from the driver's seat. Only use the supplied bass remote controller and the associated cable. The bass level remote
controller only works in LP/BP mode.
The LEVEL INPUT controller determines the input sensitivity (adaptation to the output signal of the head unit). The controller
10
range is between 5 volts (MIN) and 0.2 volts (MAX).
The HIGH PASS controller determines the frequency cut-off downwards. The crossover frequency is continuously variable from
11
10 Hz to 500 Hz.
12
The LOW PASS controller determines the frequency cut-off upwards. The crossover frequency is continuously variable from 50
Hz to 5000 Hz (5 kHz).
The X-OVER switch selects the desired operating mode:
13
FULL: Full-Range mode (the entire frequency range is amplified).
HP: High-Pass mode (frequency is limited downwards, adjustable by the HIGH PASS controller).
LP/BP: Low-Pass/Bandpass mode (frequency is limited upwards, adjustable by the LOW PASS controller). The HIGH PASS
controller then acts as a subsonic filter in this mode and limits the frequency downwards (bandpass function).
NOTE: If this is set higher than the LOW PASS, no sound is heard.
If the POWER/PROTECT is blue, the amplifier is ready for operation. If the POWER/PROTECT is red, there is a malfunction.
14
Refer in this case to the section TROUBLE SHOOTING.
15
To connect the speaker cables, use the enclosed wire harness and plug it into the SPEAKER OUTPUT connector.
NOTE
Installation of RCA/Audio signal cables and power supply cables.
Ensure while installation not to lead the audio cables between the head unit and the amplifier together with the power supply wires
on the same side of the vehicle. The best is a real separated installation on the left and right cable channel of the vehicle to avoid
interferences on the audio signal. This stands also for the enclosed bass-remote wire, which should not be installed together with the
power supply wires.
FUNCTIONAL INSTRUCTIONS
INPUT L
INPUT R
OUTPUT L
OUTPUT R
L +
L-
R +
R-
INPUT L+
INPUT L-
INPUT R+
INPUT R-
OUTPUT L
OUTPUT R
17
Werbung
Inhaltsverzeichnis
