Backrest Adjustment; Handle Adjustment - Kinderkraft HELSI Bedienungsanleitung

• The parking device shall be engaged when placing and removing the children
• The maximum basket load is 5 kg.
• Do not hang any bags on the parent handle.
• Any additional load, hanging on the handles of the stroller and/or behind the backrest and/or on the sides of the
stroller, causes deterioration of its stability.
• Use only parts and accessories supplied or recommended by the manufacturer. Do not use other parts or accessories.
• Lift the front suspension when going up a curb or step.
• Do not place the product near open flame or other heat sources.
• Do not use with an additional platform.
• Do not use the product on stairs and escalators.
• Be careful when folding the stroller.
I. ELEMENTS OF THE STROLLER (FIG. 1)
1. Handle
2. Folding lever
3. Upper part of the frame
4. Hood adjustment element
5. Bottom part of the frame
6. Front wheel socket
7. Front wheel
8. Steering wheel lock
9. Buttons for handle adjustment
10. Rear wheel release button
11. Rear wheel
II. ASSEMBLY OF THE STROLLER FRAME
Release the locking device (FIG.A) While holding the frame, lift the handle (FIG.B) until you hear the characteristic locking
sound (FIG.C). The hood has hook and loop fasteners that should be placed on the backrest.
III. ASSEMBLY AND DISASSEMBLY OF REAR WHEELS
Slide the rear wheels (11) into their designated holes until you hear a locking sound (FIG.D). To release the wheel, press
the button and pull out the wheel (Fig. E).
WARNING! The stroller is fitted with inflatable wheels: do not exceed the
maximum permissible wheel inflation pressure - the value indicated on the
wheel tyre.
WARNING! Before using the stroller, make sure that all the wheels are
installed correctly.
IV. BRAKE
Activate the brake (FIG.F). Raise the brake to disable the lock (FIG.G)
V. ASSEMBLY AND DISASSEMBLY OF THE BUMPER BAR
Place the bar in the appropriate places on the frame. Slide into the guides until it clicks (FIG. H). Press the buttons on bo th
sides of the bar and pull the bar up (Fig. I).
VI. SAFETY HARNESSES
The harnesses of this stroller are adapted for newborns. Fasten the harness to the buckle (FIG.J.I). Each time adjust both
shoulder and crotch harnesses (FIG.J.II). Press the button to unbuckle the harnesses (FIG.K). To install the shoulder harness
at one of the three heights, remove the lap harness from the cloth and place the shoulder harness buckle through the loop
to the selected height (FIG. L). Pull the hip belt back through the buckle.
VII. BACKREST ADJUSTMENT
The backrest can be smoothly adjusted from lying to sitting position using a buckle (FIG. M).
VIII. HANDLE ADJUSTMENT
Press the buttons for adjusting the handle (9) and set it in a convenient position (Fig. N)
IX. DISASSEMBLY OF THE STROLLER
Place the backrest in the reclining position (FIG. O.I), then fold the hood (FIG. O.II) and pull both folding levers (2) together
to fold the stroller (FIG. O.III). When the stroller is fully assembled, the frame should be secured with a side lock (FIG.P).
X. CARE AND MAINTENANCE The buyer is responsible for proper installation of all functional elements as well as for carrying
out all required maintenance and adjustments in order to keep the buggy in good technical condition. The buggy must be
12. Rear part of the frame
13. Brake
14. Bumper bar
15. Frame for the front part of the hood
16. Frame for the rear part of the hood
17. Button for detaching the bumper bar
18. Locking device after folding the frame
19. Hood
20. Seat
21. Safety harness
22. Basket
18